How to Install CWM recovery in Xolo Q700.

Tools Requirements:-
1. USB cable.

2. Charging Your battery up 80%.

3. Install Xolo Q700 Driver Using PdaNet.
Must Read:-  How to Install ADB Drivers of any Android device with PdaNet.

4. Download SP_Flash Tools :- Click Here to Download

5. Download CWM Recovery.img file:- Click Here to Download

6. V.Com Driver :- Click Here to Download

Instruction:- This Recovery process is works only Xolo Q700 so don't tray to other Xolo Devices.

Installing Process.

1. Download SP Tools and Extract in your PC.

2. Extract V.Com Driver and Install in your computer successfully.

3. Now open your SP Tools folder and Double Click on SP Flash Tools.

4. Now Click on Scatter Loading.

5. Now Select File "MT6589_Android_scatter_emmc" then Click open.

6. Check only "Recovery " file selected.
7. Now go to "windows" option and select " Write Memory" option.

8. Now go to "Write Memory" option as shown in below fig

 

9. Now then click on "EMMC"

10. Now Check all the option ones again as shown in above fig. everything is ok then press "write

       memory"

11. Now connect your Xolo Q700 with switch off and "Enable USB Debugging" is must require.

12. Just wait finish the all the process. "Don't Disconnect your Device"

13. After completion all the process then you will see this "Green Ring" Shown Below Fig

14. After this ring you have to closed this sp tools and disconnect your device.
15. Congratulations you have to successfully installed CWM Recovery.
16. Don't Switch on your device.
17. Press and Hold Volume  Up +  Power On Key for 5-10 Seconds and Done.
18. Then Press Volume Up key and Reboot system.
Good Luck.
Some Phone will not boot with this combination then tray another methods.
Press and Hold Volume Up + Power On key for 2 Second then Release Volume Up key for 1 Second, then Release Power On key for 1 Second then again press and Hold Volume Up key and Power On key.
Note:- I am not responsible if you make any mistake and damage or any other problem your devise.