How to Install CWM Recovery in XOLO Q800.

Tools Requirement:-

1.      Charging your device battery up to 80% 

2.   Enable to USB debugging to your device.(How  Go to Setting-->Development--->Check USB debugging box.)

3.      Backup to all Important Data. (Like Contact, SMS, Application, etc)

4.      Xolo Q800 Driver: - Click Here to Download.

5.      V.Com Driver: - Click Here to Download

6.      CWM Recovery: - Click Here to Download

7.      SP_Flash Tools: - Click Here to Download

Must Read: - Howto Install ADB Drivers of any Android device with PdaNet. 
Must Read: - Howto Root Xolo Q800 
Installation Process:-

1.       Download SP Tools and Extract in your PC. 

2.      Extract V.Com Driver and Install in your computer successfully. 

3.      Now open your SP Tools folder and Double Click on SP Flash Tools.

 

4.     Now Click on Scatter Loading.

5.     Now Select File "MT6589_Android_scatter_emmc" then Click open.

6.     Check only "Recovery” file selected.

7.     Now go to "windows" option and select “Write Memory" option.

8.    Now go to "Write Memory" option as shown in below fig

 

9.    Now then click on "EMMC"

10.  Now Check all the option ones again as shown in above fig. everything is ok then press "write memory"

11.  Now connect your Xolo Q800 with switch off and "Enable USB Debugging" is must require.

 

12.   Just wait finish the all the process. "Don't Disconnect your Device"

 

13.  After completion all the process then you will see this "Green Ring" Shown Below Fig

 

14.      After this ring you have to closed this sp tools and disconnect your device.

15.      Congratulations you have to successfully installed CWM Recovery.

16.      Don't switch on your device.

17.      Press and Hold Volume Up + Power on Key for 5-10 Seconds and Done.

18.      Then Press Volume up key and Reboot system.

Good Luck.

Some Phone will not boot with this combination then tray another method. Press and Hold Volume Up + Power On key for 2 Second then Release Volume Up key for 1 Second, then Release Power On key for 1 Second then again press and Hold Volume Up key and Power On key.

Note: - I am not responsible if you make any mistake and damage or any other problem your devise.