Install Official Jelly Beam 4.1.2 in Samsung Galaxy Tab-3 T211

Samsung Galaxy Tab3 T211 has a 7 inch TFT Capacitive Touchscreen with 1024 x 600 pixels Resolution Display and 16 M Colors,It has Multi touch Screen Display, It has runing on Android 4.1 Jelly Bean Os, Now in this devices has 1GB RAM, the storage memory capacity is 8 GB internal Storage Capacitiy  and 32GB Expandable Storage Capacity, The Tab 3 comes with 1.2GHz dual core processor Cortex A9 coupled with Vivante Corporation GC1000 Core GPU,3 Mega pixel rear camera with auto focus and 1.3 mega pixel front camera. 

Requirements:-

1. Original USB cable.

2. Charging Your battery up 80%.

3. Samsung Galaxy Tab 3 T211 Driver. Click here to Download

Must Read:- How to Install ADB Drivers of any Android device with PdaNet

4. Download Official 4.1.2 Jelly Bean:- Click Here to Download

5. Samsung ODIN V 3.07, Click here to Download.

Instruction:- This Official 4.1.2 Jelly Bean is works only Samsung Galaxy Tab 3 T211 so don't tray to other tab 3.

Installation Process:-

1. Enable USB Debugging in your device.

2. Switch OFF your Samsung Galaxy Tab-3 T211

3. Open the device to Download mode. (To do this Press and hold  volume Down + Home+ power 

    button Download screen should appear.)

4. After 2 second WARNING! Screen appears. Press the 'Volume UP' button to enter Download 

    Mode. Now connect your Samsung Galaxy Tab 2 10.1 P5100 in your PC through USB Cable.  

5. Run the ODIN application on the desktop. When the device is connected successfully, the ID: COM

    boxof ODIN screen will turn Blue with the COM port number. & 'Added' should appear in the message

    box in Odin.(If not, then install  Samsung Galaxy Tab-3 USB driver successfully then check it again.) 

   (Other wise don't apply next step)

6. Now from the ODIN Application screen
      A. Click the PDA button and select .tar or .md5
      B. Click on ‘Phone’ then choose file with ‘MODEM’ in its name. If the file doesn't exist, ignore this step.
      C. Click on ‘CSC’ then choose file with CSC’ in its name. If this file doesn't exist, ignore this step.
      D. Click on ‘PIT’ then choose file with .pit file.However if this file doesn't exist, then ignore this one.

Note: Ignore the last three steps (B, C and D) in case such files are not found.

7. Tick only Auto Reboot and F.Reset Time check boxes are selected in ODIN Screen.
    Tick Re-Partition option, only if the .PIT file is selected in the step 6.(If .PIT file select then tick
    Re-Partition other wise don't Tick Re-Partition box.
   Verify everything suggested in Step 6 and Step 7 is done correctly.
8. Now Click the Start Button from the ODIN application and wait for some time to flash the file.
9. Wait Until Process Finishes. As Soon As Process Done, You will See That The ID:COM Section is
    Turned Green With The Message “Pass”.
10. After Getting “Pass” Message, Disconnect Your Phone From The PC.
11. Now your  Samsung Galaxy Tab-3 T211 successfully Update Jelly Bean 4.1.2
Enjoy your Samsung Galaxy Tab-3 T211 successfully Update Jelly Bean 4.1.2
Share this links with your friends
Don't used this process to other devices other wise your mobile is damage.
Note:- I am not responsible if you make any mistake and damage or any other problem your devise.